M Series – 10L/h Chilled Drinking Fountain

Professionally designed and suitable for indoor and outdoor installation, the M Series Drinking Fountain is a free-standing refreshment solution for any space. With a choice of water bubbler only (M2 Model) and both water bubbler and bottle filler (M3 Model) outlets, freshly chilled water is accessible no matter how you want it.

Mains connected, and with a heavy-duty build, this drinking fountain is built with a 5L industrial-grade steel tank with a 10L/hour chilling capacity. This system is perfect for installation in offices, worksites, workshops, gyms and more.

Key Features

• 10L/h chilling capacity – suitable for 1-15 people
• 5L insulated water storage tank
• Industrial grade stainless-steel tank and robust construction.
• Polished stainless-steel top.
• Front panel removes for ease of servicing.
• Adjustable, tamper proof non-squirt water bubbler and drink bottle/glass filler. (Bottle filler on M3 Model only)
• Robust compressor and refrigeration system
• IP33 rated and Australian WaterMark Certification (Lic No. WMK26317)
• Optional filtration kit 

The M Series is designed with an easily removable front panel that gives instant access to all components and controls. Hassle-free filter changes and services can be undertaken without disconnecting the plumbing. 

Available with or without glass filler tap, in filtered or unfiltered configurations with a stainless steel or dark grey powder coat finish, the M-Series in the perfect water cooler for factory, gym, school or construction sites.

We recommend using a licensed plumber to install this unit.

Purchased a filtered version and time to change the filter?
💧 Find replacement filters here. 

Unpack

1. After unpacking the water fountain, wipe with a soft cloth. Check the unit for evidence of rough handling.
2. Place the machine on a hard, flat surface. Make certain the unit is level. The unit should not be close to sources of heat, otherwise performance may be affected.

Install

The installation must be in accordance with AS/NZS 3500.1 and AS/NZS 3500.2. Pipe jointing is a trade skill and Aqua Cooler recommends this process is performed by qualified personnel only.

1. Ensure proper ventilation by allowing 75 mm clearance on each side of the fountain.
2. Minimum water pressure is 100 kPa and maximum is 700 kPa.
3. The recommended maximum water inlet temperature is 38°C.
4. Install a 40 mm waste trap onto the waste outlet on the rear of the fountain - not supplied.
5. Water in connection is secured via a 1/2” kinko nut and olive into the stainless-steel connection on the rear of the unit. It is recommended that a 1/2” shut off valve is installed at this point for ease of future maintenance.
6. Turn on water supply and hold down bubbler to purge the system of air until a steady stream of water comes from the tap.
7. For models equipped with a glass filler, please remove the white tubing from the hole and then assemble the glass filler by placing the neck into the hole on the top of the lid, as shown below.
8. The bubbler needs to be adjusted for the correct water flow in relation to the local water pressure. On the side of the bubbler is an inner and an outer screw. Once you have established water flow, adjust the inner screw until the stream is in the centre of the stainless-steel top.
9. Check all connections for water leaks.
10. Flush fresh mains water through the unit for five minutes to ensure any residual water from testing is cleared.
11. Plug the fountain into the building electrical supply. The unit will start automatically.

Enjoy